I've attached pictures of the old & new zoeller 503, and a close up of the old and a close up of the new, I'm going to attach pictures if I can figure attachments out. I had a Zoeller 503 installed by a plumber at it failed this winter, so I bought another Zoeller 503 to replace the bad one.īut, I notice a few differences and wonder if these are just normal adjustments. Is there anything that can be done, or will I simply need to clean out the sump periodically? I assume this is a common problem with sewer ejection pumps? We are very careful that NOTHING but toilet paper goes in (no paper towels, baby wipes, etc). The paper will continue to accumulate of top. When the sewer discharge from the building empties into the tank, it seems that the toilet paper will naturally float to the top of the liquid, so grinding it and pumping it will not occur. I cleaned out the sump and replaced the pump and it's again operating perfectly. When I opened the sump, there was a large accumulation of toilet paper on top, which appears to have interfered with the float switch operation. When I built it, I could not get enough fall for a gravity drain to the septic tank, so I installed a sewage ejector pump immediately outside the building, which has a discharge to pump the waste to the septic tank.Īll has been great for the last couple of years however, a couple of days ago, the pump failed. I have a small building on my property with a toilet, sink and shower.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |